[caption id="attachment_36" align="aligncenter" width="300" caption="Bandsawing the body shape"][/caption] [caption id="attachment_37" align="alignright" width="300" caption="Blank joined pieces of hoop pine"][/caption]

                    During the last post, I talked about drawing acoustic guitar shapes.That involved freehand drawing of graceful curves.There is not too much measuring required, namely the lower bout, waist and upper bout. Check out the latest electric guitar shape that I drew from looking at a small picture. It won’t be an exact copy, but it is near enough to look the part. If you learn to make a guitar (electric), you will need to do lots of measuring to get the proportions right. This electric guitar project needed lots of straight line drawing and several opposite edges were either in line or parallel to each other. The key to getting the proportions right was to decide the scale length (string length) of the guitar, and all other measurements of the body had to relate to the fret spacings.

[caption id="attachment_24" align="alignleft" width="150" caption="parlour"][/caption] [caption id="attachment_23" align="aligncenter" width="150" caption="000 size"][/caption] [caption id="attachment_18" align="alignright" width="150" caption="dreadnaught"][/caption]

When you learn to make a guitar, you want it to sound good, and you want the shape of it to look good.Guitars of all shapes and colours have been used as a tool to attract attention for some time now. If there is a shape out there that you like, then copy it onto paper or cardboard or plywood. If you would rather have a go at drawing your own shape, then get some drawing paper (newsagents), and begin by drawing a body centerline.The length of this line will basically determine the size of the instrument. You need to mark the upper bout width, waist width, and lower bout width. The parlour guitar is the smallest shown here (photos are not quite to scale), and the dreadnaught is the largest. Once you start drawing freehand, you will soon see how tricky this process is. I was a draftsman for many years, but all my straightline drawing didn’t help much here. You need to draw fluent, elloquent lines.The jumbo guitar size is not shown here, because of the size of the wood needed to make such a guitar. You only need to draw one half of the body, because when you make the wood body template, it is flipped over on its edge to the reverse side to make an identical half.